LFD Lamp RADIO-L8L Φ200

Triggering the light wave:
– arrange the lamps as needed so that they create a
wave- turn on the first lamp with the ON/OFF switch (after switching on the lamp will start pulsing with a flash light after about 1.5 seconds)
– then turn on the second lamp of the set (it should pulse alternately with the first lamp)
– when the two lamps work together, turn on the third lamp and wait for them to form a light
wave- turn on each subsequent lamp in the set when the previously started lamps work properly
– you can create a wave from any number of lamps (after the 10th lamp, the wave cycle repeats, the 11th lamp shines together with the first one)

Lamp coding (radio channel change):
– turn off the lamp with the ON/OFF
switch – press the internal button for coding and hold it to turn on the lamp with the ON/OFF
switch – after starting the lamp, release the coding button (the signal LED will inform you about entering the coding mode)
– by pressing the coding button set the next channel from 2-9 (the controller informs about the selected channel: 2 blinks – 2 channels, 3 blinks – 3 channels etc.)
– after coding, turn off the lamp with the ON/OFF
switch – after switching off, proceed as in the “starting the light wave” point